Harbor Freight Tools 90178 Manuale Utente Pagina 1

CEMENT MIXER - 3.5 CUBIC FOOTWITH BRIGGS & STRATTON 3.5 HP ENGINEModel 90178ASSEMBLY AND OPERATING INSTRUCTIONS3491 Mission Oaks Blvd., Camarillo,

SKU 90178 PAGE 10Flat Washers (part #10), four Spring Washers (part #9), and four Nuts (part #50)to secure the two Mixing Blades to the inside Drum as

FIGURE ISHAFT(#35)FIXING PLATE(#18)FIGURE JINNER COVER(#23)SHAFT(#35)SKU 90178 PAGE 1114. Align the four mounting holes in the Engine Mount Plate (par

HEX HEAD BOLT (#27)FLAT WASHER (#19)SPRING WASHER (#20)NUT (#21)HEX HEAD BOLT (#27)FLAT WASHER (#19)SPRING WASHER (#20)NUT (#21)BOLT (#48)FLAT WASHER

16. Unscrew the Thrust Screw (part #17) located in the Large Pulley (part #26). Alignthe Keyway Slot of the Large Pulley with the Key on the Shaft (p

18. Align the four mounting holes in the base of the Engine (part #14) with the fourmounting slots in the Engine Mount Plate (#12). Insert four Hex B

OPERATING INSTRUCTIONS1. IMPORTANT: ALWAYS make sure the crankcase of the gasoline Engine(part #14) is filled to the proper level with a premium quali

SKU 90178 PAGE 16         

11. After discharging the cement mix, raise the Degree Adjusting Arm (part #38) upto its original position. (See Figure Q.)12. Repeat Steps #5 throug

NOTE: Some parts are listed and shown for illustration purposes only, and are notavailable individually as replacement parts.SKU 90178 PAGE 18PARTS LI

ASSEMBLY DIAGRAMNOTE: Some parts are listed and shown for illustration purposes only, and are notavailable individually as replacement parts.SKU 90178

PRODUCT SPECIFICATIONSSAVE THIS MANUALYou will need this manual for the safety warnings and precautions, assembly,operating, inspection, maintenance a

6. Do not overreach. Keep proper footing and balance at all times to preventtripping, falling, back injury, etcetera.7. Industrial applications must

3. Keep a safe clearance around the Cement Mixer. Keep all people (except theoperator) a minimum of six feet from the Mixer during operation.4. Keep

Dispose of fluids and cleaning materials in accordance with all local, state, orfederal codes and regulations. Store oil rags in a covered metal cont

SKU 90178 PAGE 6UNPACKINGWhen unpacking, check to make sure all the parts shown on the Parts List on page 18are included. If any parts are missing or

SKU 90178 PAGE 7WHEEL (#5)PIN (#4)FLAT WASHER (#3)FIGURE BWashers (part #10), two Spring Washers (part #9), and two Nuts (part #8).(See Figure C.)HEX

HEX HEAD BOLT (#27)FLAT WASHER (#10) NOT SHOWNSPRING WASHER (#9) NOT SHOWNNUT (#8) NOT SHOWNDEGREEADJUSTINGPLATE(#37)DEGREEADJUSTINGARM(#38)SPRING(#39

7. Align the six mounting holes of the Connector Seal (part #45) with the six mount-ing holes in the Upper Drum (part #47). Then, glue (not included)