Harbor Freight Tools 14 in. x 40 in. Lathe with 7 in. Sander Manuale Scaricare il pdf (Pagina 19)

Page 19SKU 67690 For technical questions, please call 1-800-444-3353.

TROUBLESHOOTING

Problem Possible Cause Possible Solution

Quality of cut is poor. 1. Cutting tool is dull.

2. Cutting too aggressively.

3. Cutting tool is too far above

workpiece center line.

4. Lathe speed too slow.

1. Sharpen or replace cutting tool.

2. Use a lighter touch.

3. Lower cutting tool to max.

1/8” above the center line of

workpiece.

4. Increase lathe speed.

Excessive vibration when turning

thin workpieces.

1. Cutting tool is positioned below

workpiece center line.

2. Cutting too aggressively.

1. Raise cutting tool to center line

of workpiece.

2. Use a lighter touch.

Excessive vibration when turning

larger workpieces or bowls.

1. Headstock and/or tailstock

improperly located at ends of

workpiece.

2. Workpiece is unbalanced.

1. Check for proper workpiece

centers.

2. Trim stock until workpiece is

more balanced.

Lathe will not turn on. 1. Cord not connected into

electrical outlet.

2. Blown fuse or tripped circuit

breaker.

3. Electrical outlet not working or is

of wrong voltage.

1. Connect to electrical outlet.

2. Replace fuse or reset circuit

breaker.

3. Make sure lathe is plugged into

a working, 120 volt, grounded,

electrical outlet.

Lathe will not turn off. 1. Damaged or faulty power switch

and/or internal wiring.

1. Unplug the lathe from its

electrical outlet immediately.

Do not operate lathe until it is

repaired by a qualied service

technician.

Follow all safety precautions whenever diagnosing or servicing the Lathe.

1 2 ... 14 15 16 17 18 19 20 21 22

Commenti su questo manuale

Nessun commento

Harbor Freight Tools 14 in. x 40 in. Lathe with 7 in. Sander Manuale Pagina 19

Commenti su questo manuale

Prodotti e manuali riguardandi Torni Harbor Freight Tools 14 in. x 40 in. Lathe with 7 in. Sander